We built this halogen bulb to handle one thing and one thing only: the brutal, non-negotiable demands of flash curing. This isn’t your average lamp. It’s a thermal tool, pure and simple. It was born to deliver intense, focused heat when your process speed depends on a cycle that’s measured in seconds.
Here’s the heart of it.
We went with a 20.25-inch length and packed it with 1600 watts of power. Why? To create a serious amount of watt-density. That means the heat is concentrated into a small, tight space. Exactly what you need to flash-cure a coating or set an adhesive in a flash. It runs on 240V. This gives you a rock-solid power supply and keeps the current draw on the line manageable. Just know this: you’ve got to wire it up to a properly rated 240V circuit. No shortcuts.
The design is all about staying strong.
The halogen cycle does a pretty neat trick: it keeps the quartz envelope clean, so the light output stays consistent over the life of the bulb. This design also lets the filament run hotter, which means it heats up faster. And the R7s base? It’s a double-ended, linear connector that gives you a solid, reliable connection. It’s simple, it handles high current, and once it’s in, it stays put—even with vibration.
What it feels like to use.
With flash curing, the whole point is to blast to the target temperature, hold it, and then shut down. This bulb responds instantly. It cuts cycle times. But here’s the thing: that intensity is real. The heat density is high, so your reflector assembly and your machine’s cooling system need to be up to the task. Treat this like the precision component it is, not just another bulb, and it’ll hold its own on the line, day after day.